You may print this page for your file

Hysol ® 7460
Hot Melt Adhesive


Typical Properties
Test Method
Softening Point, RB, F                                          275                                             ASTM E28
Viscosity @ 350F, cps                                           6700                                            ASTM D3236
Heat Resistance, Pine, 2 psi load                          210                                              HTPSK-1
Open Time, Sprayed, Seconds                              30
Application Temperature,F                                  400


Application
Best results are achieved when sprayed 3-9" above the substrate.  Apply at 400F with the Hysol 4210 series Spray Tool™.  Apply at 350F - 375F in a bulk applicator.


Availability
Polyshot Cartridges for the Spray Tool™                               Pellets for bulk applicators.

Technical Consultation Service
Our technical staff and representative are ready to assist in solving any special bonding requirements. You are invited to take advantage of our extensive experience, laboratory services and trained field service staff. Call 800.323.5158 now and let us help you with your adhesive needs.

DISCLAIMER: The information supplied in this document is for guidance only and should not be construed as a warranty. All implied warranties
are expressly disclaimed. Including without limitation any warranty of merchantability and fitness for use: All users of the materials are responsible
for assuring that it is suitable for their needs, environment and use. All data is subject to change as Dexter deems appropriate. 

Users should review the Material Safety Data Sheet (MSDS) and product label for the material to determine possible health hazards, appropriate
engineering controls and precautions to be observed in using the material. Copies of the MSDS and label are available upon request. 

For more information or to order contact the Glu Guru™ at 1-800-323-5158
or
Email mike@on-hand.com